SpeedyBee F405 WING MINi Fixed Wing Flight Controller

FC BOARD

• UART: 6 sets (USART1, USART2, USART3, UART4, UART5, UART6 - Dedicated for Wireless board Telemetry connection)
• Dual Analog Camera Switching: Switch between C1 and C2
  
• LED: 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator (Red)
• PWM: 12x (9x pin headers + 2x solder pads + 1x "LED" pad)
• ADC: 4x (VBAT, Current, Analog RSSI, Analog AirSpeed)
• I2C: 1x Used for magnetometer, digital airspeed sensor
• CRSF(crossfire, elrs) Receiver: Supported, connected to UART1
• SBUS: Built-in inverter for SBUS input (UART2-RX)
• IMU (Gyro & Accelerometer): ICM-42688-P
• MCU: STM32F405, 168MHz, 1MB Flash
• Analog RSSI: Supported, Named as "RS"
• Blackbox: MicroSD Card Slot
• Barometer: SPL006-001
• OSD Chip: AT7456E
• Weight: 5.6g
• Supported FC Firmware target:
  • INAV: SpeedyBeeF405WING (default)
  • ArduPilot: SpeedyBeeF405WING

PDB BOARD

• Battery Current Sensor: 80A continuous, 150A peak Connected to FC board Current (Scale 195 in INAV, 50 A/V in ArduPilot)
• Battery Voltage Sensor: Connect to FC board VBAT, 1K:10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ArduPilot)
• FC BEC output: Output 5.2V +/- 0.1V DC Continuous current 2 Amps, 3A Peak
• Servo BEC output: Output 5V +/- 0.1V DC Continuous current 4 Amps
• Input voltage range: 7-26V (2-6S LiPo)
• TVS Protective diode: Yes
• Weight: 5.5g

WIRELESS USB EXTENDER

• Buzzer: 5V Active Buzzer
• USB Port Type: Type-C
• Weight: 3.2g

Total weight is 23g